AW-CFP2166-4

Posted by: cstcoegypt Comments: 0


Product Features
4 Zone Fire Alarm Control Panel Specification
1. It is modularized design, the panel can expend from 1 zone to 32 zones easily.
2. It has 2 level control mode by a lock
3. It has 24VDC and 5VDC power supply output.
4. It has FIRE and FAULT signal output.
5. It has 2 general sounders output.
6. Each zone has 1 circuit detectors input
7. Each zone can be disable by a button.
8. It has RESET button to reset the panel.
9. It has SILENCE button to stop BUZZER and SOUNDERS.
10. It has EVACUATE button to start a manual fire alarm immediately.
11. It has battery low protection function, when battery voltage lower than 21VDC
battery will be cut off automatically until the mains power is on.
12. It has an optional GSM module for fire alarm by SMS

Technical parameters
AC INPUT 220VAC 50HZ +10%
-15%
DC OUTPUT 24VDC typical
Voltage for MCU 5V for power board MCU, 3.3V for others
Current at 24VDC from PSE 450mA standby current
Maximum current from PSE 2A except batteries charge
Batteries current 1.85A maximum, current limited
Auxiliary output 24VDC +/- 10%, 100 mA max,
current limited, monitored
Batteries 2*12V/ 2.3Ah sealed lead acid gel,
self-regulated
2*12V/ 7Ah if needed
Battery replace Resistance 2Ω±10% if needed
Battery low-voltage protection 22.2V
Detectors connection allowed each zone 20 (except MCPs)
Zone alarm current 6mA minimum/ 27mA maximum
Sounder output 2*0.75A maximum
Fire protection 100mA maximum
Fire routing 100mA maximum
Fault routing 100mA maximum
Communication protocol 2 wires RS485 bus system
Relay contacts rating Dry contacts (NO/NC) 1A @24VDC
EOL resistor for zone 6.8K 1W
EOL resistor for outputs 6.8K 1W
Fuse on power board 3A/ 250V glass tube fuse 20mm
Fuse on EMI board 1A/ 250V glass tube fuse 20mm
Environmental Class A temperature range: -5 to 40°C (23~104°F)
Humidity: 5 to 95% RH, non-condensing
Terminal blocks rating All terminals rated for 12 to18 AWG
(0.75 to 2.5 mm2)